A SERVICE OF

logo

4 Replacement Procedures 4.13 HDD
Installing the HDD
To install the HDD, follow the steps below and refer to the figures in the preceding
section.
1. Slide the HDD connector firmly into place on the HDD, being careful not to damage
the connector pins.
2. Wrap the HDD in the HDD shielding ensuring that the circuit board face of the drive
is covered by the black part of the shielding. The circuit board must not come into
contact with the silver portion. .
3. Seat the HDD in the HDD case and secure with four M3×3 screws.
4. Seat the HDD unit in the HDD slot and secure it with two M2.5×4 black screws.
4-42 Satellite P20-25 Series Maintenance Manual