Optional Equipment (for qualified installers only) 39
Travis Industries 100-01142 4050114
Stone or Cast Inserts
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
1 Remove the stove top and place it upside down on a suitable non-scratching work surface (see the
illustration on page 19). Remove the clips holding the cast inserts in place. Install the new inserts and
secure using the clips – do not over-tighten and take care to not scratch the stone surface.
Phillips
Screwdriver
Place the stone inserts into the indents on the
stove top. Attach with the clips and screws.
NOTE: slide the inserts inwards as
far as possible to prevent them from
striking the sides of the cast body.
2 Two insert retainers hold the side inserts in place. On models shipped without side inserts, they are
included in the owner's pack. If the side inserts are in place, loosen the screws on the insert retainers
until they become loose (on some models they may be installed from behind). Remove the cast side
inserts (if applicable). Slide the side inserts into place (take care to not scratch the surface). Replace
the side insert retainers and tighten the screws until the side inserts become secure (do not over-
tighten).
5/16" Nutdriver
Insert Retainer (the retainer "bows" when it is
tightened, securing the stone insert in place)
Stone Insert
