Optional Equipment (for qualified installers only) 37
Travis Industries 100-01142 4050114
3 Attach the wiring harness following the directions below (do not plug in the power cord at this time).
Do not plug
the heater in
until
installation is
complete.
Attach the black and white wires
labeled “Blower” to the blower
(orientation does not matter).
11/16" Nutdriver
Remove one of the nuts holding
the blower in place. Insert the
screw through the eyelet on the
green ground wire and replace.
b
c
d
Route the wires labeled “Valve
on/off” and “Solenoid” under
the burner pan to a location
near the gas control valve.
a
Attach the two black wires
labeled “Snap Disk” to the
snap disk (orientation does
not matter).
f
e
Insert the molex connector on the power cord through the
hole on the blower cover and attach it to the molex
connector on the wiring harness. With the outer black
casing of the power cord 1" through the hole, install the
strain relief. The strain relief is best installed using pliers to
Attach the two black wires labeled
“Rheostat” to the rheostat wires
(orientation does not matter).
4 Attach the blower cover and rheostat control rod (and knob) following the directions below. Make sure
all of the wiring is placed away from the blower impeller and the bottom of the burner. Use lock ties, if
necessary, to ensure no wires are damaged.
b
c
Remove the three screws used
to attach the blower cover from
the back of the stove.
a
1/16" Allen
Attach the
rheostat control
rod to the
rheostat.
Position the blower cover in
place from below, making sure
the rheostat control rod inserts
through the hole on the control
box.
Attach the rheostat knob.
5/16" Nutdriver
Rheostat Control Rod
Rheostat
d
5 Plug the blower in. Let the heater achieve operating temperature and test blower operation.
