The Adapter includes a Remote Controller, which features several buttons
allowing you to control the Media Navigator. Use the remote to move through
the Navigator’s Music, Pictures, or Help menus on your TV.
To install the batteries, follow these instructions:
1. On the back of the remote, remove the battery panel.
2. Insert the included AAA batteries into the battery compartment. Make sure
you align the batteries according to the compartment’s diagrams.
3. Replace the battery panel.
Here are descriptions of the remote’s various buttons.
Power - Turns the Adapter on or off.
Menu - Displays the main menu.
Music - Displays the Music menu.
Pictures - Displays the Pictures menu.
Setup - As the Adapter is connecting to
the TV, press this button to view the TV
Setup screen. For more details, refer to
“Chapter 7: Connecting the Wireless-B
Media Adapter to Your TV and Stereo.”
Select and arrows - Use the Select button
to make a selection, like the Enter key on
your computer’s keyboard. Use the arrow
keys to move through menus, songs, or
pictures.
Page up and down - Use these buttons to
scroll through lists of songs or pictures.
Volume up and down - Press these buttons to control the volume.
7
On the Adapter’s back panel, it features seven ports and two buttons.
Power The Power port is where you will connect the power adapter.
LAN The LAN port is where you will connect the Ethernet net-
work cable.
Uplink If the Adapter is connected to a wired network device, the
Uplink button is what you will push depending on whether
the device is a PC or switch. If the Adapter is connected to a
PC, then the Uplink button should be pushed in. If the
Adapter is connected to a switch, then the Uplink button
should NOT be pushed in.
Video The Video port is where you will connect the video cable.
Left and Right The Left and Right ports are where you will connect the left
and right audio cables.
S-Video The S-Video port is where you will connect the S-video
cable.
Reset The Reset button is what you will push if you need to reset
the Adapter.
(Antenna) The Antenna port is where you will attach the antenna.
6
Note: When you reset the Adapter, press the Reset button and hold it
in for 10 seconds.
Back Panel
Figure 3-2
Remote Controller
Figure 3-3
