57
Satellite
Select the satellite to be searched, using the
buttons. Make sure your reception system is
aligned to the selected satellite. You can search only one satellite at a time. If you have connected
a multi-feed reception system (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East), you
must repeat this procedure once for each satellite. You can however start the fi rst installation again,
in the course of which a channel search of all the satellites you selected is performed.
Press the
button to move to the next selection item.
Channel Search Mode
Use the
buttons to select whether you wish to search “free & scrambled”, “free channels only”
or “scrambled only” channels.
To view scrambled channels you need the appropriate CA (Conditional Access) module
and a valid smart card together with a valid subscription to the relevant pay TV provider.
Press the
button to move to the next selection item.
Network Search
Use the
buttons (On/Off) to select whether a network search should be performed. If you
set the network search to “Off”, only the factory stored transponders of the satellites you previously
selected will be searched for new as yet unlisted channels.
If you set the network search to “On”, the transponder network enables additional transponders that
have not yet been stored to be located. They are then stored and searched for new channels in the
same way as the existing transponders.
When you have made your settings, use the
buttons to select “Start Search” and press
the
button to start the search. You can cancel the search at any time by pressing the
button.
During the search you will see the following message (example):
TV channels found
Radio
channels found
Progression bar
Satellite with the
transponder
currently being
searched
SEARCHING FOR CHANNELS (CHANNEL SEARCH)
