Adding and removing satellites
In the next step, move with
o u to e.g. the entry „User1“.
After pressing the
- or + button, you are asked if you want to add the
satellites.
Confirm it with
O.
The following message appears
You can now make the respective entries to your receiving system in
the corresponding positions using the
o,u and - or + buttons
and exit the menu by pressing
L three times. At the same time the
new station data is stored.
Entering a satellite name
You can change the satellite name in the LNB configuration menu
using the number buttons. Refer to section "operating instructions" for
information about the exact procedure.
Removing a satellite
To remove a satellite, select the "LNB configuration" menu, move the
cursor bar with
o or u and confirm by pressing the - or +
button. You will now be asked whether you wish to remove the
satellite. You can either confirm your selection with
O or cancel
with
L.
43
