A SERVICE OF

logo

Open as PDF
next previous
Scanning 35 mm Slides and Film 73
Placing 35 mm Film Strips on the Film Holder
1. Remove the film cover for the film strip holder.
2. Slide your film strip into the holder with the duller (emulsion) side facing up.
The top of the images should be facing the outside edge of the film holder and
the images should be reversed.
3. Replace the film cover. (It should snap into place.)
4. Position the film holder so that the 35 mm film strip faces the center of the
scanner glass. The positioning posts on the film holder fit in two small holes
near the scanner lid, as shown.
5. Continue on page 75 to scan your film.
SP RX600 Users Guide.book Page 73 Thursday, January 29, 2004 1:08 PM