34 Printing on Roll Paper, CDs, DVDs, and Card Stock
Loading Roll Paper
1. Remove the tape and protective paper from the end
of the roll. Then insert the holders into the roll of
paper as shown.
2. Make sure the end of the paper is cut straight across,
with 90° corners. If the end is cut diagonally, you
may have problems feeding the paper.
3. If the paper curls at the end, fold a sheet of paper
over the end and roll it backward to uncurl it.
Avoid touching the printable surface of the roll
paper.
4. Remove any paper that’s in the sheet feeder at the
top of the printer. Then remove the paper support,
lower the output tray, and turn on the printer.
5. Make sure the adjust lever is set to
the m position.
Note: You can load and print on roll paper with the
paper support (and sheets) in place. However, you
may find it easier to remove them.
sp960basics.book Page 34 Friday, January 17, 2003 2:39 PM
