Eiki International LC-WB42N Manual

next previous

Maintenance and Cleaning

Thisprojectorusesahigh-pressurelampwhichmustbehandledcarefullyandproperly.

Improperhandlingmayresultinaccidents,injury,orcreateafirehazard.

●Lamplifemaydifferfromlamptolampandaccordingtotheenvironmentofuse.Thereisnoguarantee

ofthesamelifeforeachlamp.Somelampsmayfailorterminatetheirlifeinashorterperiodoftime

thanothersimilarlamps.

●Iftheprojectorindicatesthatthelampshouldbereplaced,i.e.,iftheLAMPREPLACEindicatorlights

up,replacethelampwithanewoneIMMEDIATELYaftertheprojectorhascooleddown.

  (FollowcarefullytheinstructionsintheLampReplacementsectionofthismanual.)Continuoususeof

thelampwiththeLAMPREPLACEindicatorlightedmayincreasetheriskoflampexplosion.

●ALampmayexplodeasaresultofvibration,shockordegradationasaresultofhoursofuseasits

lifetimedraws toanend.Risk ofexplosionmaydifferaccording totheenvironmentor conditionsin

whichtheprojectorandlamparebeingused.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.

If a lamp explodes, disconnect the projector’sAC plug from theAC outlet immediately. Contactan

authorized servicestationfor acheckupofthe unit andreplacementofthe lamp.Additionally,check

carefullytoensurethattherearenobrokenshardsorpiecesofglassaroundtheprojectororcomingout

fromthecoolingaircirculationholes.Anybrokenshardsfoundshouldbecleanedupcarefully.Noone

shouldcheck theinsideof theprojectorexceptthose whoareauthorized trainedtechniciansand who

arefamiliarwithprojectorservice.Inappropriateattemptstoservicetheunitbyanyone,especiallythose

whoarenotappropriatelytrainedtodoso,mayresultinanaccidentorinjurycausedbypiecesofbroken

glass.

LAMP HANDLING PRECAUTIONS

Resetting the Lamp Counter

BesuretoresettheLampcounterafterthelampisreplaced.WhentheLampcounterisreset,theLAMP

REPLACEindicatorstopslightingandtheLampreplacementicondisappears.

Note:

 DonotresettheLampcounterwithoutimplementing

lampreplacement.BesuretoresettheLampcounter

onlyafterreplacingthelamp.

Lamp counter Reset?

appears.

SelectYes,thenanother

confirmationboxappears.

SelectYesagaintoreset

theFiltercounter.

PresstheMENUbuttontodisplaytheOn-Screen

Menu.UsethePoint▲▼buttonstoselectSettingand

thenpressthePoint►ortheSELECTbutton.

UsethePoint▲▼buttonstoselectLamp counter

andthenpresstheSELECTbutton.UsethePoint▲▼

buttonstoselectLamp counter resetandthenpress

SELECTbutton.Lamp counter Reset? appears.

SelectYestocontinue.

Anotherconfirmationdialogboxappears,selectYesto

resettheFiltercounter.