156 Dell™ Printer Configuration Web Tool
Printer Settings
The Printer Settings tab includes System Settings, Network Settings, USB Settings, PCL Settings, PostScript
Settings, PDF Settings, Secure Settings, Copy Defaults, Copy Color Balance, Copy Settings, Fax Defaults, Fax
Settings, Scan Defaults, and USB Direct Print Defaults pages.
System Settings
Purpose:
To configure the basic printer settings.
Va lues:
PS Fonts List Click Start to print the PS Fonts List.
PDF Fonts List Click Start to print the PDF Fonts List.
Job History Click Start to print the Job History report.
Error History Click Start to print the Error History report.
Print Meter Click Start to print the Print Meter report.
Color Test Page Click Start to print the Color Test Page.
Protocol Monitor Click Start to print the Protocol Monitor report.
Speed Dial Click Start to print the Speed Dial report.
Address Book Click Start to print the Address Book report.
Server Address Click Start to print the Server Address report.
Fax Activity Click Start to print the Fax Activity report.
Fax Pending Click Start to print the Fax Pending report.
Stored Documents
*1
Click Start to print the Stored Documents list.
*1
This item is available only when RAM Disk is enabled or the optional hard disk is installed.
Power Saver Time - Sleep Sets the time taken by the printer to enter Sleep mode after it finishes a job.
Power Saver Time - Deep Sleep Sets the time taken by the printer to enter Deep Sleep mode after it has
entered Sleep mode.
mm / inch Sets the measurement unit to be used on the touch panel as either mm or
inches.
Display Brightness Sets the brightness level of the touch panel screen.
Control Panel Tone Sets the volume of the tone that is emitted when the operator panel input is
correct, or disables the tone.
Invalid Key Tone Sets the volume of the tone that is emitted when the operator panel input is
incorrect, or disables the tone.
Machine Ready Tone Sets the volume of the tone that is emitted when the printer becomes ready,
or disables the tone.
Copy Completed Tone Sets the volume of the tone that is emitted when a copy job is complete, or
disables the tone.
Job Completed Tone Sets the volume of the tone that is emitted when a job other than a copy job
is complete, or disables the tone.
Fault Tone Sets the volume of the tone that is emitted when a job ends abnormally, or
disables the tone.
Alert Tone Sets the volume of the tone that is emitted when a problem occurs, or
disables the tone.
