SHOW LINK
/FULL
Equivalent to specifying
/FACILITY/STATE
.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in
node-list
.If
node-list
is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
.If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
/STATE
/NOSTATE (D)
Specifies that a detailed status of the specified link(s) is displayed.
Related Commands
•
SET LINK
•
CREATE FACILITY
•
SHOW FACILITY/LINK
Example
RTR> SHOW LINK/FULL IRON
Links:
To Node: iron Address: iron.zuo.dec.com
Status:-
Outgoing message sequence nr: 22 Incoming message sequence nr: 22
Current receive buffer size: 2048 Current transmit buffer size: 2048
Current number of link users: 1 Write buffer timed out: no
Write buffer full, may be sent: no Write buffer allocated: yes
I/O error detected in write: no I/O error detected in read: no
Pipe temporarily blocked: no Connection broken: no
Write issued, not completed: no Read is pending: yes
Node initiated the connection: yes Connection established: yes
Connection in progress: no Node is configured: yes
Link is in disabled state: no Link may be suspect: no
Facilities:-
In facility: steve2
Frontend: no Router: yes Backend: no
Router -> Frontend: no Frontend -> Router: yes
Backend -> Router: no Router ->Backend: no
Router quorate: no Backend quorate: no
Router current: yes Backend coordinator:no
This example shows
• The name and network address of the partner node.
• Link status.
• Name of facility using this link and how the link is used in the facility.
RTR Command Line Interface 6–145
