6-4
Installation Guide for Cisco Unity Release 5.x with IBM Lotus Domino (Without Failover)
OL-13599-01
Chapter 6 Setting Up Domino and Installing Lotus Notes
Installing and Configuring Lotus Notes on the Cisco Unity Server
Step 11 Confirm that the network is configured so that Cisco Unity can resolve the unqualified Domino server
name to an IP address. (For example, if the Domino server name is MailServer and you enter ping
mailserver on the command line on the Cisco
Unity server, the response is the IP address of the Domino
server.)
Installing and Configuring Lotus Notes on the Cisco Unity Server
You install Notes on the Cisco Unity server because Cisco Unity communicates with Domino by using
the Notes software.
You can also use Notes for troubleshooting (for example, to determine whether messages are getting
from the Cisco
Unity server to Domino users), but you must stop Cisco Unity before you start Notes.
When you are finished troubleshooting, exit the Notes software, and shut down and restart the
Cisco
Unity server.
Caution Do not run Notes on the Cisco Unity server while Cisco Unity is running, or Cisco Unity may stop
functioning.
Caution Do not install an unsupported version of Notes on the Cisco Unity server. For a list of Notes versions
supported on the Cisco
Unity server, refer to the applicable System Requirements for Cisco Unity at
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_installation_guides_list.html.
Caution Do not install csClient or csiNotes, the client component of DUC for Cisco, on the Cisco Unity server.
Do the following three procedures in the order listed.
To Install Lotus Notes on the Cisco Unity Server
Step 1 On the Cisco Unity server, insert the IBM Lotus Notes disc in the DVD drive.
Step 2 Browse to the Lotus Notes directory, and double-click Setup.exe.
Step 3 Follow the on-screen prompts, and accept the default settings until you are prompted to enter a user name
and organization.
Step 4 Enter a user name and organization, and click Only for Me.
Step 5 Click Next.
Step 6 When you are prompted to specify destination folders, for both the program and the data folders, use the
drive location for binary files that you made note of in the
“Determining the Locations for Files on the
Cisco Unity Server” section on page 2-4.
Make note of the drive and directory for the program folder because you will need this information for
the next procedure.
Step 7 Click Next.
Step 8 Follow the on-screen prompts, and accept the default settings.
