1-35
Catalyst 4500 Series Module Installation Guide
78-13267-06
Chapter 1 Module Overview and Specifications
Gigabit Ethernet Switching Modules
The ports on this switching module can be configured with any combination of
shortwave (SX), longwave/long-haul (LX/LH), and long-range (ZX) GBICs. For
a description of GBICs, see the “Installing, Removing, and Maintaining GBICs”
section on page 2-8.
WS-X4424-GB-RJ45
The WS-X4424-GB-RJ45 24-port 10/100/1000BASE-T Gigabit Ethernet
switching module (see Figure 1-32) has the following specifications:
Note You must use Category 5 cables when connecting to the 1000BASE-T ports on
this switching module.
Figure 1-32 WS-X4424-GB-RJ45 24-Port 10/100/1000BASE-T Gigabit Ethernet Switching Module
Ports on this switching module may be oversubscribed, depending on utilization.
For further information on these ports, see the “Configuring Gigabit Ethernet
Ports” section on page 3-9.
Specification Description
Module type 10/100/1000 Fast or Gigabit Ethernet switching
module
Port duplex mode Half or full duplex mode at 10 and 100 Mbps; full
duplex mode only at 1000 Mbps
Port speed 10, 100, or 1000 Mbps
Number of ports 24
Connector type RJ-45 (See Figure 2-1 on page 2-2.)
Cable type UTP
49435
WS-X4424-GB-RJ45
STATUS
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
24 PORT
10/1000/BASE-T
MULIT-SPEED
GIGABIT ETHERNET SWITCHING
MODULE
