14-3
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 14 Configuring Auto Smartports Macros
Configuring Auto Smartports
Figure 14-1 Cisco Medianet Deployment Example
Configuring Auto Smartports
• Default Auto Smartports Configuration, page 14-3
• Auto Smartports Configuration Guidelines, page 14-4
• Enabling Auto Smartports, page 14-5
• Configuring Auto Smartports Default Parameter Values, page 14-6
• Configuring Auto Smartports MAC-Address Groups, page 14-7
• Configuring Auto Smartports Macro Persistent, page 14-8
• Configuring Auto Smartports Built-In Macro Options, page 14-9
• Creating User-Defined Event Triggers, page 14-11
• Configuring Auto Smartports User-Defined Macros, page 14-15
Default Auto Smartports Configuration
• Auto Smartports is disabled globally and enabled per interface.
• CDP fallback is disabled globally and enabled per interface.
• Cisco IOS shell is enabled.
• Auto Smartports macros are used by default when ASP is enabled for the devices shown in
Table 14-1.
Auto Smartports macro
configuration applied to the port
Switch with Auto
Smartports enabled
Device Identified through CDP, 802.1x,
MAB, LLDP, MAC address, or OUI
206545
Ta ble 14-1 Auto Smartports Built-In Macros
Macro Name Description
CISCO_PHONE_AUTO_
SMARTPORT
This macro applies the IP phone macro for Cisco IP phones. It enables QoS, port-security,
sto
rm-control, DHCP snooping, and spanning-tree protection. It also configures the access and
voice VLANs for that interface.
CISCO_SWITCH_AUTO_
SMARTPORT
This macro applies the switch macro for Cisco switches. It enables QoS and trunking with
80
2.1Q encapsulation. It also configures the native VLAN on the interface.
