The Programming
Assistance Button (a.k.a.
PAB.)
The PAB is located on the
side of the Module. This
push button mimics the
Hood-Pin switch in order to
avoid having to get out of
the vehicle and pressing the
Hood-Pin switch. The PAB
will work only when the
Hood is up.
Before Programming a Transmitter
The Transmitter is not delivered pre-programmed: it must be programmed after the wiring of
the Module is completed.
The Module has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
programmed, the code of the first Transmitter will be erased from memory.
How to Program the Transmitter.
1. FLASH the Hood Pin Switch.
Before the 20 seconds have passed, turn the Ignition Key to the IGNITION ON (RUN) position
and then to the OFF position.
2. Press and hold button , until the vehicle gives 5 flashes. The Module has stored the
Transmitter in its memory.
3. Close the Hood, to exit.
Table 1
How to Enter Programming Options Mode
The System is equipped with two custom Programming Modes, allowing the installer to
custom-fit the system according to the requirements of each vehicle. When getting into the
Programming Option Mode, the Parking Lights will flash once, twice depending on the option
you have entered. The unit will stay in Programming Mode until the Hood Pin-switch or the
Brake Pedal is pressed again; therefore take your time to make the proper selection. To
return to the Programming Centre (Main Menu), press on the Brake Pedal.
1. FLASH the Hood Pin Switch.
Before the 20 seconds have passed,
2. Press and hold the Brake Pedal, then press one of the following buttons on the
Transmitter:
Button ,to enter Mode 1;
Button ,,to enter Mode 2.
The Parking Lights will flash once or twice to confirm entry into a mode.
3. Release the Brake Pedal.
Table 2
The Module can only be programmed Function by Function. After selecting a Mode (1
or 2), you will be taken to the first Function of that Mode. After entering an Option selection
for Function 1, you will be automatically taken to Function 2, and so on; therefore, be ready
AS-1412 Installation Guide P. 9
