P. 2 Installation Guide AS-1412
Introduction
This Guidebook contains all information pertinent to the installation. Most (if not all) features
are grouped in the User Guidebook and therefore, should you need information on a feature,
you should refer to the User Guidebook.
Included in the Package
Before beginning the installation, please review the Installation Guide – especially the Wiring
Diagram and the Programming Options.
It is very important that you familiarize yourself with the programming and operation of the
system, even if you have already installed such a system in the past. There are many great
new features that may be overlooked if you do not read the manual; this would prevent you
from maximizing the potential of the Module.
Prior to the installation, make sure that all the hardware components required to install the
system are in the box.
The following is a list of components included in the kit:
1 – Control Unit
1 – 2-button Remote Transmitter
1 – R-1 Interconnect Cable
1 – R-1 Receiver
1 – Hood Pin-switch
1 – 6 Pin Main Ignition Harness
1 – 5 Pin Secondary Harness
1 – 12 Pin Accessories Harness
1 – Warning label, User Guide
The plug-in valet and the 2-volt plug-in
LED are not included with this model.
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device. To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more
than that required for successful communication".
FCC USER NOTICE:
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modi-
fications to this equipment. Such modifications could void the user’s authority to operate the
equipment.
