P. 8 Installation Guide AS-1412
12 YELLOW
(+) Glow-plug
input
(Cont.)
-plug input on the Module may be “timed out”. The
Module will power up the Ignition and Glow-plug circuits
and simply wait for the time-out before starting:
Connecting the Glow-plug input wire of the Module to
Ignition will hold the ignition
ON for the maximum
waiting time (25 sec., recommended).
Keeping the Glow-plug input wire of the Module
unconnected will hold the ignition
ON for the minimum
waiting time (3 sec., not recommended in very cold
environments).
Connect the Glow-plug wire to the Ignition wire only
after Tach has been programmed (i.e.: Connecting the
Glow-plug wire is one of the very last steps in the
installation process
Flashing the Hood Pin
What is flashing the Hood Pin?
It is a procedure that makes the Module go into the Programming Centre. Once the Module
is in the Programming Centre, the Installer has no more than 20 seconds to get into one of
the sub-menus. Failure to do so will result in the Module exiting the Programming
Centre and the Installer will have to Flash the Hood Pin once more.
Remember: You can use the Programming Assistance
Button instead of the Hood Pin any time the Hood is up.
The Installer … The Module …
1. Press and hold the Hood pin for 4 seconds.
2. Let go of the Hood Pin. Parking Lights “ON”
3. While the Parking Lights are on, press down the Hood
Pin once more.
4. Release the Hood Pin again. “ON” for 20 seconds
5. You now have 20 seconds to select one of the sub-
menus.
Once inside the Programming Centre, the Installer has a selection of many different sub-
menus. Once you are in the Programming Centre, you have the option of the following
menus:
a) Transmitter Programming ………………….. p.9
b) Programming Options …………………..… p.10
c) Honk Horn Timing* (*if available) ………..… p. N/A
d) Tach Programming …………………..……… p.11
Remember: You have up to 20 seconds, once the Parking Lights are on Solid, to select a sub-
menu, Failure to do so will result in the Module exiting the Programming Centre and the Installer
will have to Flash the Hood Pin once more.
