Configuring System Settings
41-001190-01 Rel. 1.1, Rev. 00 4-7
Configuring AastraLink Pro 160 System and Network Parameters
7 To support additional languages for the auto-attendant announcement, click on any of the following
parameters. Only the system language set by the administrator during initial greenfield configuration
is enabled by default.
• Support English
• Support French
• Support Spanish
Note: Adding additional languages may require the IP phones to reboot, in order to download the
new language pack.
8 To specify settings for the Line Type, Line Range/Boost, and Line Profile, you must use the
AastraLink Tuning Wizard. For instructions, see “Using the AastraLink Audio Tuning Wizard” on
page 4-85.
9 In the “Echo Cancel” field, echo cancellation is enabled by default. This parameter enables echo
cancellation for the FXO lines. Disable this parameter by unchecking the box.
Note: Aastra recommends echo cancellation should always be enabled in normal use; re-enable it
after running the tuning wizard if required.
10 Specify the decibels to use for power when Real Time Transport Protocol (RTP) is sent TO the line, in
the “RTP to Line Power (dB)” field.Valid range is +6 dB to –14 dB. Default is -3.
Note: Aastra recommends you DO NOT change the default setting for this parameter because of
FCC regulatory compliances.
11 Specify the decibels to use for power when Real Time Transport Protocol (RTP) is sent FROM the
line, in the “Line to RTP Power (dB)” field. Valid range is +6 dB to –14 dB. Default is 0.
Note: Aastra recommends you DO NOT change the default setting for this parameter because of
FCC regulatory compliances.
12 Click <Save> to save your changes.
AastraLink Web UI
Step Action
