Filter
Top Products
Chapter 3 SHD1111 Programming
Z-Wave Series Programming Guide
14
0: OFF
1-99: ON (Binary Switch Device)
Dim Level (Multilevel Switch Device)
3.1.3.2 Configuring the OFF Delay
Configuration Parameter #2 can adjust the time of delay before the OFF command is transmitted.
This parameter can be set from of 1 ~ 127 seconds of delay.
3.2 Advanced Programming
3.2.1 Battery Check Command
The Z-Wave Controller may enquire the battery status of the SHD1111 by sending BATTERY_ GET.
Once the SHD1111 receives the command, it will return BATTERY_REPORT command to the
controller.
If the message shows "Battery Level = 255 (0xFF)", it implies that the SHD1111 is at low battery
status. Please replace the batteries as soon as possible, otherwise the SHD1111 will shut down.
3.2.2 Wakeup Command Class
The SHD1111 stays in sleep status for the majority of time in order to conserve battery power.
However, it can be waken up by the WAKE_UP_INTERVAL_SET command set by the Z-Wave
Controller.
After the SHD1111 wakes up, it will send Wakeup Notification Command to its association nodes
and stay awake for 5 seconds if it doesn’t receive any WAKE_UP_NO_MORE_INFORMATION
command.
The minimum and maximum wakeup interval is 60 seconds and 194 days respectively. Allowable
interval among each wakeup interval is 1 second.
FUNCTION PARAMETER SIZE (BYTE) RANGE DEFAULT
Basic Set Level 1 1 0~99 99
FUNCTION PARAMETER SIZE (BYTE) RANGE DEFAULT
Basic Set Level 2 1 1~127 1
BATTERY_REPORT
[Command Class Battery, Battery Report, Battery Level = 20%-100%]
FUNCTION DEFAULT
Basic Set Level 99
Period of Wake Up Notification 1 hour