Filter
Top Products
35
The hinge plate assembly is slotted so it can be moved up,
down and sideways by approximately 3mm to adjust the
position of the door in relation to the appliance.
—Once the desired position has been achieved ensure
the screws are firmly tightened against the hinge plate
assembly to maintain the position.
7. ADJUSTING DOOR CATCH & HINGES
7.1 To maintain the safe use of your appliance, you may need
to adjust the door hinges to ensure the door closes safely
and correctly.
7.2 To adjust the door catch:
—Open the door to gain access to the catch.
—Use a 13mm A/F spanner to loosen the half lock nuts
either side of the appliance body. This will allow the
dome catch to rotate in and out (see diagram below).
PR8740
Dome catch
WasherStove body
Half lock nuts
—Once the desired setting has been achieved ensure the
lock nuts are tightened against the appliance body.
7.3 To adjust the door hinge plate assembly:
—Open door and lift free of hinge plate.
—Lay the door face down on a soft, flat surface, to protect
the paintwork and glass.
—Use an M6 hexagon key to loosen the 4 x M6 screws.
PR8741
M6 screws
x 4
MAINTENANCE and SERVICING
Organisations authorised to certify competence in the
installation of domestic solid fuel appliances
(Competent Persons Scheme):
aPHC - Association of Plumbing and Heating
Contractors (Certification) Ltd.
www.aphc.co.uk
BESCA - Building Engineering Services Competence
Accreditation Ltd.
www.besca.org.uk
HETAS - Heating Equipment Testing and Approval
Scheme Ltd.
www.hetas.co.uk
NAPIT - National Association of Professional Inspectors
and Testers Ltd.
www.napit.org.uk
NICEIC - NICEIC Group Ltd.
www.niceic.org.uk
HETAS Approved Chimney Sweeps:
NACS - The National Association of Chimney Sweeps
www.chimneyworks.co.uk
APICS - The Association of Master Chimney Sweeps Ltd.
www.apics.org
The Guild of Master Chimney Sweeps
guildofmasterchimneysweeps.co.uk