Filter
Top Products
CONTROLS
86037580 GLIDE 01/03/07
3-12
12. BRAKE PEDAL
The brake pedal is located on the floor to the right side of the steering column pedestal. The pedal operates
the disc brake on the drive wheel. To slow or stop the vehicle, apply pressure to the brake pedal.
13. PARKING BRAKE LEVER
The black knob located on the right side of the steering column pedestal is used to set the parking brake. To
set the parking brake, fully depress the brake pedal and push the parking brake knob. To release the parking
brake, fully depress the brake pedal. Then release pressure on the brake pedal. The parking brake knob will
return it to its’ released position.
FOR SAFETY: Before leaving or servicing machine; stop on level surface, set parking brake, turn off
machine and remove key.
14. DIRECTIONAL CONTROL PEDAL AND SPEED REDUCTION FEATURE
This pedal controls the direction of travel and the speed of the vehicle. Slowly pressing the front of the pedal
causes the machine to travel forward. Pressing the rear of the pedal causes the vehicle to travel in reverse.
The vehicle speed can be controlled by varying the pressure on the front or rear of the pedal.
FOR SAFETY: The vehicle can coast for a short distance after releasing the directional pedal.
Remove the foot from pedal and use brakes to slow or stop the machine.
SPEED REDUCTION FEATURE
Maximum speed of machine can be decreased to 80% of maximum by disconnecting wire 3 white from wire 16
white, located between controller and LCD display. Machine is set at 100% speed setting at factory.
FORWARD
REVERSE