Filter
Top Products
MAINTENANCE-PAD DRIVER
86306300 CHARIOT BURNISHER 11/09/07
4-8
PAD DRIVER REPLACEMENT
Turn key switch on to lower deck down. Make sure
pad adjustment knob is turned fully in the up position
(-) counter clockwise. Use needle nose vise grips to
clamp together spring retainer bars between spring.
Remove the four bolts holding deck assembly onto
frame. Two bolts on each side.
Label and remove wires coming off of motor.
Disconnect by unplugging motor wire harness from
machine wire harness. Take note cable tie
locations.
Slide deck out from under machine and turn
deck assembly over on to motor. Remove pad
lock and pad.
Attach metal ring (86082070 – PRV NO. 629000)
using same screws that held pad lock keeper.
Screw in spacer (862454470 – PRV NO. 739000)
into motor shaft.