Filter
Top Products
OPERATING
THE
ADP
Remove clear dome from upper tank.
Do
not
remove the two vacuum hoses.
1.
NOTE: Dome can be set securely
between handle uprights when the
handle is in operating position.
2.
Lift upper recovery tank from machine
and set aside.
Vacuum the carpet and make sure it is
cleared of surface debris before
cleaning with the ADP.
Release handle lock lever located on the
lower right side of the handle and lower
handle to a comfortable operating
position. Lock the handle in position.
Use a clean bucket to fill solution tank
with hot water. Add a non-foaming
concentrate for use in hot water ex-
tractors at the proportions noted on the
container.
NOTE
The ADP cleans by pulling
back-
wards over the carpet.
3. Adjust brush to proper
cleaning position by using
the lever located at the lower
back of the motor housing.
Start at No. 1 “New Brush”
(black) position. If more
CAUTION:
To avoid possible distortion of
polyethyl-
ene solution/recovery tanks, DO NOT
carpet pile agitation is de-
sired, lower brush setting
one position at a time.
USE WATER TEMPERATURE THAT EX-
CEEDS 140” F (60” C).
Make sure dome is seated correctly to en-
sure proper vacuum seal.
CAUTION:
Use only the suitable chemicals listed be-
low. Using incompatible chemicals will
damage the machine. Damages of this
type are not covered under warranty.
Carefully read ingredients on manufac-
turer’s label before using any product in
this machine.
4.
SUITABLE
CHEMICALS
Alkalis
Clorox II Bleach*
Defoaming Agents
Detergents
Hydroxides
Oxygen Bleaches
Soaps
Sta-Puf Fabric Softener*
Vinegar
White Monday Bleach*
INCOMPATIBLE
CHEMICALS
Aldehydes
Aromatic Hydrocarbons
Butyls
Carbon Tetrachloride
Clorox*
Chlorinated Bleaches
Chlorinated Hydrocarbons
D-Limonene
Lysor*
Methyls (MEK)
Perchlorethylene(perc)
Phenols
5.
1.
2.
l
Registered Trademark
Trichlorethylene
98198
7/l/97
Accessory Tool Position
Check to be sure spray manifold valve
is set at the “Carpet Spray” position and
that the brush motor circuit breaker on
the control panel is in.
Tilt the machine back on rear wheels
until brush is off the floor. Turn on the
brush and vacuum switches.
NOTES:
Starting the machine with dry brush
resting on carpet may trip the brush
motor circuit breaker.
The vacuum motor is also protected by
a circuit breaker. This breaker will only
trip under conditions of abuse, such as
an overflowing recovery tank.
5