Filter
Top Products
MAINTENANCE-VACUUM
86292490 VOYAGER DUO 11/15/08
4-20
VACUUM SHOES
The dual offset vacuum shoes are designed to
extract soiled solution from the carpet. The plastic
vacuum shoe glides minimize wear to flooring.
MAINTENANCE
The vacuum shoes should be removed and cleaned
daily to ensure maximum recovery.
VACUUM SHOE REMOVAL
1. Unscrew retainer knob from right side vacuum
shoe.
2. Pull vacuum shoe forward until it is free from
pivot pin.
3. Remove vacuum hose from top of vacuum shoe
4. Repeat to remove left side vacuum shoe.
5. Inspect or repair as necessary and reinstall.
TO CLEAN VACUUM SHOES
1. With the vacuum shoes in the raised position,
turn key switch “off”.
2. Remove vacuum shoes.
3. Flush vacuum shoes from top with water. If
necessary, clean blockage from narrow opening
with a scraper or similar device.
4. Vacuum shoe glides may be removed for
cleaning (or replaced) by removing the three
pins that secure them to metal vacuum shoes.
RECOVERY TANK FLOAT SHUT-OFF
When water is no longer being vacuumed from the
floor and the vacuum fan is operating, the ball float
has engaged. The vacuum motors will not vacuum
water with recovery tank full. The recovery tank
must be drained.
1. The float shut-off screen can be cleaned in or
out of the machine.
2. To clean the float shut-off while it is inside the
machine wipe material off screen then rinse.
Check that the ball is also clean and moves
freely.
3. To remove the float shut-off, grasp the elbow
with one hand tilt and pull the float screen
assembly to pull it off the elbow.
4. To install, place one hand on the elbow, and
then tilt and push the float screen assembly over
the elbow.