Filter
Top Products
11 | P a g e
Window kit Installation in a double-hung window
1. Open window or sliding door for approximately 5”
2. Cut the foam seal (adhesive type) to the proper
length and attach it to the bottom of the
window. Fig.10.
3. Adjust the length of the window bars to the same
length and width of the opening of the window.
Cut the window piece if necessary to fit the
length of your window. Fig. 11.
4. Close the window on the window slide bars. For
long term installation, you may screw the window
kit into your window frame. Fig. 12.
5. Cut the foam seal to the length and seal the
open gap between the top window sash and
outer window sash. Shown in Fig.13
.