Filter
Top Products
5
OPERATING YOUR THERMOSTAT
Before you begin programming your thermo-
stat, you should be familiar with its features and
with the display and the location and operation
of the thermostat buttons. The information in
this section will help you become familiar with
your new thermostat so that you can easily
program it.
Your thermostat consists of two parts: the ther-
mostat body and the subbase.
Use
SYSTEM
HEAT - OFF - COOL - AUTO
to turn thermostat OFF be-
fore removing or attaching the thermo-
stat body. Equipment damage and/or per-
sonal injury could occur.
The subbase is attached to the wall, but you can
remove the thermostat body for easy program-
ming. To remove the thermostat body from the
subbase, grasp the thermostat body and gently
pull it out from the bottom of the subbase and
pivot up. To attach the thermostat body, line up
the four terminal pins on the upper section of the
thermostat back with the matching connector on
the subbase. Insert these, then gently pivot the
thermostat body down to connect the eight pin
connectors on the lower portion of the thermo-
stat back. Gently push until the snap connectors
engage. DO NOT FORCE OR PRY THE THER-
MOSTAT as this may damage the unit.
CAUTION
!