Filter
Top Products
3
Using your thermostat
Home, Sleep and Away Temperature
Pre-Sets
You can set your (Home, Sleep, Away) temperatures for use
when you get home, go to sleep, or leave home. Then, just
press the button you want and go.
Favorite Temperatures are set at the factory as indicated in
the following table. You can use pre-sets or change to different
temperature pre-sets.
Factory Pre-set Temperatures
HEATING COOLING
70
o
F 75
o
F
SLEEP
62
o
F 78
o
F
62
o
F 83
o
F
Your Pre-set Temperatures
HEATING COOLING
SLEEP
Sleep Timer Option
The sleep timer will automatically change the thermostat from the Sleep to Home temperature after the number of hours set in
the configuration menu. The Sleep timer default is 8 hours and can be changed to a setting between 1 to 12 hours.
Example: You have selected 8 hours for the Sleep timer in the configuration menu. Press the Sleep button, the thermostat will
maintain the sleep temperature for 8 hours. After 8 hours the thermostat will go back to the Home temperature. The Sleep timer
will be activated each time the sleep button is pressed.
Change Filter Reminder Option
The thermostat can display a reminder when it is time to change the air filter on your heating and cooling system. The Change
Filter will automatically display after the number of hours set in the configuration menu. The change filter reminder time default
is 200 hours and can be changed to a setting of 25 to 1975 hours; 200 hours is approximately 3 months.
Example: You have selected 250 hours for the change filter reminder. The thermostat will display change filter after 250 it has
counted down 250 hours. When “Change Filter” is displayed, press the
or button to clear the display and restart the
timer.
Cool Savings™ Option
With Cool Savings enabled, the thermostat will make small adjustments to the desired temperature during periods of high
demand to reduce cooling system running time and save energy. When the cooling system has been running for more than
20 minutes, humidity in the home will be lower and a higher temperature will feel comfortable. After 20 minutes of run time,
the thermostat will start increasing the desired temperature in steps of less than one degree as the system continues to run.
These adjustments will eventually cause the system to satisfy the thermostat and turn the system off to reduce the energy
consumption. When the Cool Savings feature is active and making adjustments, the display will flash “Save”. The amount of
adjustments to the desired temperature is dependent on the Cool Savings value that is set, 1 being the least adjustment and 6
being the most adjustment. With this feature set to OFF, no change will occur when the cooling system is continuously running
during the periods of high demand. Periods of high demand will normally occur during the late afternoon and early evening on
the hottest days of the summer.
Change Home, Sleep and Away
Temperature Pre-sets
1. Move SYSTEM switch to HEAT position.
2. Using the
or button, set the desired temperature.
3. Press and hold the Home, Sleep, or Away button for 3
seconds. The display will go blank (except for the battery
icon and heat/cool icon) and back on again indicating that
the thermostat has saved your pre-set.
4. Repeat the process for the remaining Pre-sets to be
changed.
5. Move SYSTEM switch to COOL to Pre-set Temperatures
for cooling.
Use Home, Sleep and Away Temperature Pre-Sets
1. Press the Home, Sleep, or Away button. The display
will show the icon for the button pressed and display the
temperature setting.
2. The thermostat will maintain the selected pre-set
temperature until you change it by pressing the or
button or selecting another Pre-set Temperature.