Whirlpool X10002W0 Air Conditioner User Manual


 
Changing
air direction.
Locate tabs at the bottom or the top of
flow (right, left or straight). A tab in the
the grille and move the tab in the
center of the grille area on some models
direction in which you want the air to
will adjust air flow up or down.
System
Control Setting
I
Cooling is wanted
I
Cooling is Not
wanted
I--
Select a ‘Cool’ setting
1 Select ‘Fan Only’ 1
1 Select a ‘Cool’ setting 1 Select ‘Fan Only’ 1
I
Select a ‘Cool’ setting
I
_____________
Select a ‘Coor setting
Select a ‘Cool’ setting
Select a ‘Cool’ setting
S&~a”C~rsetJ~g
Select “Fan Only’
Select ‘Fan Only’
Select ‘Fan Only”
________ -___ _
I
tab I I
tab
Cleaning your
air conditioner.
Electrical Shock and Personal Injury
Hazard
- Set System Control to the “Unit
Off”
position. Unplug power
supply cord or disconnect power
supply at the fuse or circuit
breaker box before cleaning and
maintaining your air conditioner.
n
Do Not drink any water that
collects within
air conditioner.
This water is not sanitary.
. Do Not use cleaning fluids,
solvents,
abrasive cleaners, or
strong detergents. These may
damage air conditioner parts.
Failure to follow these instructions
may result in personal injury or
damage to the air conditioner.
J
Cleaning the air conditioner front panel
and filter regularly, every two weeks,
will help to ensure longer life and lower
operating costs. The filter helps to
remove dust, lint and other particles
from the air.
Disconnect power supply cord before
starting cleaning process.
1.
Press down on the top edge of front
panel until it releases from the
cabinet.
2.
Pull front panel toward you. Lift up
and away from bottom spring clips.
3.
Remove elastic band from the back
side of the front panel. Remove
filter.
4.
Use vacuum cleaner to remove dust.
If the filter is very dirty, wash filter
in warm water using a mild
detergent. The filter should air dry
before you replace it. Do not use a
hair dryer to dry the filter.
5.
Use a soft cloth soaked in warm
water with mild detergent to clean
the front panel. Rinse the front
panel and dry. Clean the control
area
with a soft dry cloth.
6
. Place filter in back of front panel.
Replace elastic band.
7
. Put bottom of front panel into spring
clips. Press down on top edge of
front panel and push panel toward
unit. Snap front panel tabs into
place in cabinet.