Filter
Top Products
Important Safety
Instructions
Reduce risk of fire, electrical
shock or personal injury when
using air conditioner by following
these basic precautions:
. Complete all of the Installation
Instructions to prevent product
operating problems and possible
personal injury.
m Read all operating instructions
before using air conditioner.
I Do Not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or
any other appliance. The fumes
can create fire hazard or
explosion.
. Use only a properly grounded
electrical outlet. Check with a
qualified electrician if you are in
doubt as to whether the air
conditioner is properly
grounded. Do Not modify the
plug on the power cord. If it
will not fit the outlet, have a
proper outlet installed by a
qualified electrician.
1 Do Not use an extension cord.
I Do Not have a fuse in the
neutral or grounding circuit.
Starting your air conditioner.
1.
Set the Exhaust Control’ to the
“Closed” position or the Air Control
to
the “Off” position depending on
which
feature your air conditioner
has. This
position will provide for
maximum cooling.
*Consoles shown may vary slightly from
vour air conditioner. The controls on
jr0u.r air conditioner will operate the
same as explained in this section.
Save these instructions
Using special features.. .
Exhaust Control
Use this feature to draw stale or smoky air
from the room or to circulate air in the
room.
See the chart to determine what settings to
select for the type of air control you desire.
Note: Energy efficiency is decreased when
exhausting room air and cooling at the
same time.
Air Control
Use this feature to draw stale or smoky air
from the room or to circulate fresh air from
the outside into the room.
See the chart to determine what settings to
select for the type of air control you desire.
Note: Energy efficiency is decreased when
exhausting room air or circulating fresh air
into the room and cooling at the same time.
2.
Set the System Control to the
desired setting. Suggestions are as
follows:
Lo Cool - for sleeping comfort
Med Cool
- for normal cooling
Hi Cool - for maximum
cooling
Fan Only - for air circulation
without cooling.
3.
Set the Thermostat Control to
number 6. You can adjust the
cooling performance by resetting
the Thermostat Control to a higher
number for more cooling or to a
lower number
for less cooling. You
will need to experiment to find the
setting which you prefer.
If you turn your air conditioner off,
wait two or three minutes before
turning it back on. The amount of
time to wait is printed on your
console. You may blow the fuse in
the fuse box or trip the circuit
breaker if you Do Not follow these
instructions.
Exhaust Control
Room air desired
I
Exhaust Contrc
setting
Exhaust room air
“Open’
Circulate room air
‘Closed
I
cooling only
I
‘Closed
Air Control
I
Room air desired
I
Air Conlzol
setting
Exhaust room air
Circulate fresh air
into the room
Circulate room air
cooling only
‘Exhaust”
‘Fresh Air”
-off
‘Off