Filter
Top Products
21
Customizing Features/Options -- Model WHES20
Recharge
Recharge button is used to i nitiate a n immediate recharge.
• Press and hold the
RECHARGE button untilthe words “RECHARGE NOW” flashes
in the display, and the softener enters the fill cycle of regeneration right away.
“RECHARGE NOW” will flash during the regeneration. When over, full wa ter
conditioning ca p acity is restored.
RECHARGE NOW Initiated
NOTE:
Avoid usinghot water while the conditioneris regenerating, because the water heaterwill
refill with bypass hard water.
Recharge Tonight
If you do not want to start an immediate recharge, but would like an extra recharge at the next preset
recharge time, do the f ollowing to schedule a recharge.
• Press and release (do not hold) the
RECHARGE button. The words “ RECHARGE
TONIGHT” f lashes in the display,and the softener will recharge at thenext r echarge time.
“RECHARGE NOW” will flash during the regeneration. When over, f ull water
conditioning ca p acity is restored.
RECHARGE TONIGHT Initiated
‘‘Power---Outage Memory’’
If electrical power to the water softener is lost, ‘‘memory’’ built into the timer circuitry will keep all
settings f or up to eight hours. While the power is out, the display is blank and the water softener will
not re generate. When electrical power is restored, the following will occur.
1. You have to reset the present time only if the display is flashing. The HA RDNESS and
RECHARGE TIME never require resetting unless a change is desired. Even if the clock is
incorrect after a long power outage, the softener works as it should to keep your water soft.
However, regenerations may occur at the wrong time of day until you reset the clock to the correct
time of day.
NOTE:
If the water softener was regenerating when power was lost, it will now finish the cycle.