Filter
Top Products
Handle
1. Unplug power cord.
2. Remove front panel. (See page 5.)
3.
4.
5.
6.
Slide unit out of cabinet by using the handle in
the center of the base flange.
Wrap the motor, connector plug, electrical
control box and compressor terminal box in
plastic film and make sure no water or other
liquid gets inside any of these parts. lt could
damage the insulation and cause serious
mechanical problems.
Carefully clean and hose out the base,
condenser coil and condensate pans. Clean at
least once a year or more often if the con-
denser coil and pan collects dirt, sand, leaves,
insects or algae. Also, clean if you detect an
odor coming from the air conditioner.
Remove plastic film from motor and electrical
parts.
7. Replace unit in cabinet.
8. Replace front panel.
9. Reconnect power supply.
NOTE: lt is a good idea to wait 24 hours before
starting the unit again. This allows time for all
areas to dry out. The water from rainfall or from
normal operation does not harm these compo-
nents.