Whirlpool ACE184XR0 Air Conditioner User Manual


 
6
1. Remove air conditioner from carton and place it on
cardboard.
2. Remove shipping screws from each side wall of cabinet.
3. Remove front panel from air conditioner and set aside.
4. Remove ground screw and ground wire from front of air
conditioner base. Save ground screw.
5. Pull on handle to slide air conditioner out of cabinet. Place air
conditioner on cardboard.
NOTE: Do not lift, push, pull or remove any expanded
polystyrene (foam) from inside the air conditioner. It is not
packing material.
Shipping bracket removal (on some models)
1. To remove upper shipping bracket from unit support bracket,
cut the 2 wire ties with scissors.
2. Lift the end of the upper shipping bracket off of the unit
support bracket and remove the other end from compressor
flange.
3. Remove screw from end of lower shipping bracket attached
to divider wall using a ¹⁄₄" nut driver or socket wrench.
4. Remove the other end of lower shipping bracket from
compressor flange.
NOTES:
If compressor flange interferes with sliding air conditioner
back into cabinet, bend flange back against the compressor.
Reinstall shipping brackets only if unit will be moved from its
present location.
Installing the Cabinet in a Window
Handle air conditioner gently.
Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
The place where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded
3prong outlet.
Do not block the louvers on the front panel.
Do not block the louvers on the outside of the air conditioner.
Filler board installation
1. Center empty cabinet in window. Maintain a firm hold on the
air conditioner cabinet. Lower window sash to hold cabinet in
place.
2. Measure the distance between the right side of the cabinet
and the inside of the window channel.
3. Repeat for the left side.
A.Shipping screws
A.Green ground wire
B.Ground screw
A.Handle
A
A
A
B
A
A.Wire ties (2)
B.Unit support bracket
C.Upper shipping bracket
D.Compressor flange
E.Remove this screw
F. Lower shipping bracket
A
B
C
D
E
F