Filter
Top Products
9
Complete Installation
1. Insert the foam seal without adhesive strip behind the top of
the lower window sash and against the glass of the upper
window.
2. Place the window lock bracket as shown. Use a ¹⁄₈" drill bit to
drill a starter hole through the hole in the window lock bracket
and into the upper window.
3. Attach the window lock bracket to the upper window with
one ³⁄₄" screw to secure the window in place.
4. Plug into a grounded 3 prong outlet.
5. Press RESET on the power supply cord. See “Electrical
Requirements.”
6. Remove the clear plastic film from the control panel and
plastic front.
INSTALLATION INSTRUCTIONS—10K BTU, 12K BTU
Unpack the Air Conditioner
Remove Packaging Materials
■ Handle the air conditioner gently while unpacking the unit.
■ Cut the 4 plastic bands that secure the carton.
■ Remove the carton top and lift the air conditioner from the
base pad.
■ Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
■ Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
■ Remove any packaging materials inserted into the side
louvers.
■ Dispose of/recycle packaging materials.
A.Top of lower window sash
B.Foam seal
A.Window lock bracket
B.Upper window
A
B
B
A
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
Failure to do so can result in back or other injury.