Filter
Top Products
4
INSTALLATION REQUIREMENTS
Tools and Parts—All Models
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Supplied
Check that all parts are included in parts package.
Location Requirements—All Models
IMPORTANT: Observe all governing codes and ordinances.
Check the location where the air conditioner will be installed.
Make sure you have everything necessary for correct installation.
The location should provide:
■ Grounded electrical outlet within 6 ft (183 cm) of where the
power cord exits the air conditioner.
NOTE: Do not use an extension cord.
■ Free movement of air in room to be cooled.
■ A large enough opening for the air conditioner. Installation
parts are supplied for double-hung windows.
■ Adequate wall support for weight of air conditioner. Air
conditioner weighs 50 lbs to 75 lbs (22.7 kg to 34 kg).
NOTE: Cabinet louvers must not be obstructed. Air must be able
to pass freely through the cabinet louvers.
Window Installation
Window Opening Measurements—Small Chassis:
5500 Btu, 6300 Btu and 8000 Btu:
■ 21" (53.3 cm) minimum to 33¹⁄₂" (85 cm) maximum opening
width.
■ 13¹⁄₂" (34.3 cm) minimum opening height
Window Opening Measurements—Large Chassis: 10k and
12k Btu
■ 24" (61 cm) minimum to 36" (91.4 cm) maximum opening
width.
■ 15" (38.1 cm) minimum opening height.
■ Phillips screwdriver
■ Scissors
■ Level
■ Tape measure
■ Cordless drill and ¹⁄₈" bit
■ Pencil
A. Foam seal with adhesive
strip
B.Foam seal without
adhesive strip
C.Window lock bracket
D.Side bracket (on some
models)
E.
³⁄₈
" screws (4) (5500, 6300 and 8k
models only)
F.
³⁄₄
" screws (5) (6 provided on 10k and
12k models)
G.Side curtains (2)
H.Top channel seal (on some models)
I.Top channel (on some models)
A
B
C
D
EF
G
H
I
A.Cabinet louvers
A.Small chassis: 21" (53.3 cm) minimum;
Large chassis: 24" (61 cm) minimum
B.Small chassis: 13
¹⁄₂
" (34.3 cm) minimum;
Large chassis: 15" (38.1 cm) minimum
A
A
B