Filter
Top Products
5
INSTALLATION INSTRUCTIONS
Unpack the Air Conditioner
Remove packaging materials
■ Remove and properly dispose of packaging materials.
Remove tape and glue residue from surfaces before turning
on the air conditioner. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
■ Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
SMART-MOUNT
™
Tray Installation
1. Using the tray back as a template, center in windowsill
against outside edge of stool.
2. Using the 2 inside screw holes in tray back, mark screw
locations on windowsill for mounting the SMART-MOUNT
™
tray.
3. Remove tray back. Using these marks, drill ³⁄₃₂ in. pilot holes
in the windowsill approximately 1¹⁄₂ in. deep.
4. To assemble the tray frame, insert tab on tray back into slot
on tray side. Check to see that the tab is engaged and the
2 pieces are aligned. Insert 2 - #8 - 18 x ¹⁄₄ in. hex-head
screws to secure.
5. Repeat with other tray side.
Excessive Weight Hazard
Use two or more people to move and install
air conditioner.
WARNING
Failure to do so can result in back or other injury.
1. Tray back
2. Windowsill
3. Outside edge of stool
1. Tray back
2. #8 - 18 x
¹⁄₄
in. hex-head screws
3. Tray side
3
2
1
1
2
3