Filter
Top Products
14
Step 4
Install side burner locks
Note: The locks are taped to the inside of the side
burner lid.
You will need: frame assembly, two side burner locks and
a 7/16 inch wrench.
Turn frame assembly right side up.
Loosen the right rear 1/4 x 20 bolt. Install the side burner
lock. The “U” shape cut out of the lock slips down over
the bolt. Tighten with a wrench. Figure 3 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock
fits between the front panel and the frame. The “U” shape
cut out slips up over the bolt. Tighten with a wrench.
Figure 3 (b).
Figure 3
Step 5
Measure and drill holes
You will need: Completed frame assembly, base panel,
tape measure, and pencil.
ƽCAUTION: Combustible materials should never be
within 24 inches of the top, bottom, back or sides of
the barbecue. Do not locate under overhead
combustible construction.
Note - With the lid open the depth of the barbecue is
28 inches, front to back.
Set the completed frame assembly in position on your
deck, concrete pad, or patio for anchoring. Measure the
distance from the outside of the base plate to the outside
of the other base plate. It should be 37 1/4” across. Figure
4.
Note: If the measurement is not 37 1/4” across adjust the
legs as necessary so that the measurement is 37 1/4”.
Place the base panel in between the legs to insure fit.
Figure 5. Once the fit is established, remove the base
panel and mark the holes.
ƽCAUTION: A minimum of 2 bolts are required on
each side.
You are now ready to anchor the base.
Figure 4
Figure 5
37 1/4
(a)
(b)