Filter
Top Products
13
Step 2
Assemble the frame
You will need: left frame, right frame, two nylon washers,
two 1/4-20 x 1/2 inch bolts and a 7/16 inch wrench.
Note - Work on carpeted area (on grass, or on one of the
boxes) to protect the finish during frame assembly.
Put the frame pieces so the leg tabs are up. Put the right
frame to your right and left frame to your left. Figure 1.
Slip the two frame halves together with the tabs inside,
until the tabs of the right frame are inside the left frame
and the holes align. Figure 1 (a).
Slip washers over bolts; insert and tighten bolts. (If you
try to insert a bolt and there are no holes, you have the
left frame turned the wrong way. Turn the left frame
around.) Figure 1 (b).
Step 3
Continue frame assembly
You will need: frame assembly, two side frames, four 1/4-20
x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench.
Assemble one side frame onto the leg tabs of the right
frame, and the second side frame onto the leg tabs of the
left frame. Make sure the anchoring base plates are
facing in toward each other. The tabs must be on the
inside of the frames when the joints are closed.
Add front panel with the large hole down and to your
right. Add washers, then bolts. Do not full
y tighten these
bolts. You will tighten them once the base is anchored.
Figure 2 (a).
Turn frame assembly right side up.
Figure 1
Figure 2
(a)
(a)
(b)
Do not fully tighten
these bolts
Anchoring base
plates are facing in