Filter
Top Products
5
To OPEN, CLOSE, START, and STOP your
garage door opener:
1. Activate your keypad by pressing the ON/
OFF/RESET button. The keypad will illuminate.
2. Enter the 4 digit PIN (personal identification
number) for the garage door opener you want
to operate. The opener will begin to move the
door.
NOTE: The opener will not move the door
if the incorrect PIN is entered. Reset the
KEP-IV by pressing the ON/OFF/RESET
button and enter the correct PIN.
3. The KEP-IV will remain active for 15
seconds, pressing any key, except the ON/
OFF/RESET button will stop the opener from
opening the door if it is opening, and will stop
and reverse the door direction if it is closing.
KEP-IV Operation with Opener
Operation/Battery Replacement
WARNING! IF BATTERY IS SWALLOWED,
CONTACT PHYSICIAN IMMEDIATELY.
WARNING! FIRE AND BURN HAZARD. DO
NOT RECHARGE, DISASSEMBLE, HEAT, OR
INCINERATE. KEEP BATTERY OUT OF THE
REACH OF SMALL CHILDREN. INSTALL
BATTERY CORRECTLY. DISPOSE OF USED
BATTERIES PROMPTLY.
NOTE: Replace the 9 volt battery when
keypad light becomes dim or does not light
up.
1. Raise Keyless Entry Cover to expose battery
cover.
2. Snap open battery cover with a coin and
remove old battery.
3. Replace 9V battery, then replace battery
cover.
KEP-IV Battery Replacement
ON/OFF/RESET
USE KEYPAD
TO INPUT
4 DIGIT PIN
CODE
Quick
Sta rt
BATTERY
COVER
BATTERY
USE COIN TO PRY
OPEN BATTERY
COVER
1
2