Filter
Top Products
3
To program the KEP-IV to an Opener or to
change an existing PIN:
1. With new installations, it is recommended
to program the KEP-IV before mounting to wall,
otherwise proceed to Step 2.
2. Unit can be programmed with garage door in
either up or down position.
3. Press the transmitter PROGRAM BUTTON on
DoorMaster
®
light fixture, idrive
®
,
pro
drive
®
,
Quantum
®
or Classicdrive
®
opener. LED will light
or idrive
®
opener will beep once indicating that
it is ready to learn a transmitter. (See Illustration
on right)
The idrive
®
and idrive
®
Torsion opener will
remain in the learn mode for 30 seconds. The
DoorMaster
®
light fixture will remain in the learn
mode for 30 seconds. The
pro
drive
®
, Quantum
®
or Classicdrive
®
opener will remain in learn
mode for 60 seconds.
4. Open the cover of the KEP-IV, then push the
ON/OFF/RESET button of the keyless entry. The
Keyless Entry keypad will light indicating it has
been activated and is waiting for commands
(illumination may not be visible in direct
sunlight.)
5. Press the desired four digit PIN number,
then hold the “0” key until the door moves.
(example:1-2-3-4-0). Release the “0” key.
Programming is now complete.
NOTE: If at any time, an error was made in
entering the codes, simply press the ON/
OFF/RESET button and repeat the above
procedures.
NOTE: One KEP-IV can be programmed
to open multiple garage door openers. To
program for additional openers, repeat steps
1 through 5 above except input a different
four digit PIN number for each additional
opener.
Only 1 PIN can be programmed to each
garage door opener.
ON/OFF/RESET
Programming KEP-IV to Opener
Programming to Opener
IDRIVE
®
TORSION IDRIVE
®
TORQUEMASTER
DOORMASTER
®
QUANTUM
®
& CLASSIC &
PRODRIVE
®
PROGRAM
BUTTON
PROGRAM
BUTTON
PROGRAM
BUTTON
PROGRAM
BUTTON
Quick
Sta rt
USE KEYPAD TO
INPUT 4 DIGIT
PIN CODE
3
2
1