Filter
Top Products
— 5 —
LEG STAND ASSEMBLY
INSTRUCTIONS
Required Tools
7/16" Socket
Philips Head Screw Driver
13/16" Open End Wrench
Shelf
Screw
Nut
Lock
washer
Leg
assembly
Figure 1
1. Insert short end of leg into top of shelf
(Fig. 1).
2. Secure into place with one (1) screw, one
(1) lock washer, and one (1) nut per hole.
3. Repeat leg installation with three (3)
remaining legs.
Locking casters
(front)
Non-locking
casters
(rear)
Figure 2
4. Install the two (2) front locking casters into
the short end of the leg assembly (Fig. 2).
5. Install the rear non-locking casters into
the remaining two (2) leg assemblies.
Tighten nut
Figure 3
6. Secure all four (4) casters by tightening
down the nut on the underside of the
caster.
7. Ensure the two locking casters are located
on the same side of the stand. This will
now be the front of the broiler.
BROILER STAND INSTALLATION
Required Tools
13/16" Open End Wrench
1. Lower Broiler onto the four (4) legs of the
stand, supporting from under the body
bottom (Fig. 4).
Figure 4
w/