Filter
Top Products
11
English
HOW TO USE
Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Use the integrated handle for lifting and
carrying. Located on the back of heater.
2. Position the heater so airflow is not
obstructed.
3. Unwrap power cord from bottom of
heater. Plug power cord into a standard
grounded wall outlet.
COOL DOWN
When you power off your heater, it
automatically enters a cool down
routine in which the heating element
turns off and the fan exhausts
remaining heat. During Cool Down,
the display counts down from eight,
then powers off completely.
4. Touch the power button ( ) and select a
Mode ( ). Next, set thermostat to desired
temperature using (-/+). The SET TEMP numbers
will flash on the LCD Display. After five seconds
of selecting set temperature, the display will
stop flashing. You may also select Fan Only by
touching ( ). Default settings upon first use
will be High Heat and set temperature of 75
degrees.
Set timer to automatically power the unit off by
touching the ( ). The number 0 will flash on the
display. Touch ( ) to select the amount of time
in one-hour intervals, up to 12 hours. To cancel
the timer operation, select 0 hours. The timer
will set after five seconds of making a selection.
After the timer is in operation, the remaining
amount of time before the heater powers off will
countdown on the display. If you touch the ( )
during operation, the time remaining will flash,
and if the ( ) is touched a second time, the
timer will cancel.
If the heater is in sleep mode, touch
the controls once to wake and again
to adjust settings.
Wrap excess cord inside the Cord
Storage. Use the notches, located inside
the Cord Storage, to secure the power
cord in place or adjust length during use.