Filter
Top Products
ENGLISH
|
9
STEAM MOPPING
Before operating, make sure Microber Pad is properly attached (Page 7) and Boiler is
lled with water (Page 8).
1. For rst-time use, remove protective plastic cover that is shipped on electrical plug. Plug
power cord into a convenient electrical outlet.
2. Place Resting Pad on oor, so that textured side faces upward. Rest Mop Head on top of pad,
in order to help protect oor surface from excess heat and moisture during heat-up period.
3. Using your foot, gently press down on On/Off Switch until it clicks. Red Power Indicator Light
will illuminate to show that unit is receiving power. At the same time, green Heating Indicator
Light will illuminate to show that Boiler is heating.
4. After approximately 3 minutes of heating time, unit will begin emitting steam.
5. Remove unit from Resting Pad, and begin mopping.
Refer to Page 10 for a listing of oor surfaces that are recommended for cleaning with
your Everyday Steam Mop.
6. For best results, mop using a steady back-and-forth motion over the oor, working your way
backwards in order to avoid walking over the freshly mopped area.
IMPORTANT: To avoid warping or damage caused by heat and moisture, do not use on
unsealed hardwood or unglazed ceramic surfaces. Steam may remove the sheen from
some oors that have been treated with wax.
Never allow Everyday Steam Mop to rest idle on oor surfaces while still on – prolonged
exposure to steam in a single area may discolor or damage some oors. If it becomes
necessary to stop mopping at any time, always turn unit off and place back on Resting Pad.
7. Once all water has been used, green Heating Indicator Light will turn off to show that Boiler is
empty. If you wish to continue mopping, rst turn unit off by pressing down gently on On/Off
Switch until it clicks, then unplug power cord from outlet. Refer to Relling procedure on
Page 8 to rell Boiler.
8. The Microber Pad will absorb dirt and moisture during mopping. However, when you are
nished you may nd some residual moisture has been left behind. In this case, it is
recommended to allow oor time to air-dry. A fan may be directed towards mopped area to
facilitate drying.
9. Once your mopping tasks are completed, place unit back on Resting Pad and turn it off by
pressing down gently on On/Off Switch until it clicks. Unplug power cord from outlet, then refer
to procedures on Page 11 for proper storage and care of your Everyday Steam Mop.