Filter
Top Products
8
|
ENGLISH
Using Your
Everyday Steam Mop
ADDING WATER
1. Make sure On/Off Switch is set to “off” position
(red Power Indicator Light will not be illuminated)
and power cord is unplugged.
2. Carefully remove Boiler Cap by unscrewing it in a
counter-clockwise direction (FIGURE 3-A).
3. If Boiler was not emptied completely after last use,
empty all remaining water now to prevent overlling.
4. Fill included Measuring Cup with 8.5 oz. (250 ml.)
water, and pour into Boiler through Boiler Fill Hole
(FIGURE 3-B).
NOTE: In order to minimize potential mineral
build-up and prolong the life of your Everyday
Steam Mop, it is recommended that distilled or
de-mineralized water be used in the Boiler.
If distilled water is not available, then Boiler
should be cleaned frequently in order to
remove mineral build-up. Refer to Mineral
Build-Up section on Page 11 for details.
5. For maximum usable water (10 oz. / 300 ml.), ll
Measuring Cup with another 1.5 oz. (50 ml.) of
water, and add into Boiler.
6. Replace Boiler Cap by screwing it into Boiler Fill
Hole in a clockwise direction until tight (FIGURE
3-C). Unit is now ready to begin steaming – refer
to Page 9 for operating instructions.
REFILLING
If unit has been in use, always take
the following safety precaution before
removing the Boiler cap and adding water:
•
Allow unit to cool for 5-10 minutes. This will reduce
heat and pressure inside the Boiler, helping to
prevent escaping steam when the Boiler Cap is
removed as well as vaporization when more water
is added.
Once this is done, follow Adding Water procedure
above as usual.
WARNING: Failure to follow this precaution may
result in burns from escaping steam when the
Boiler cap is removed or when water is poured
into the Boiler.
FIGURE 3
3-A
3-B
3-C