Filter
Top Products
VIVOTEK
User's Manual - 7
Hardware Installation
1� Attach the alignment sticker to the wall� Drill three holes into the wall� Then hammer the
supplied plastic anchors into the holes and secure the plate with supplied screws�
2� Feed the cables through the front opening of the wall mount bracket� (If you want to use
external devices such as sensors and alarms, please refer to the assembling steps on the
next page�)
3� Hang the wall mount bracket on the plate�
4� Fix the Network Camera on the wall mount bracket with two screws on both sides�
5� Secure the wall mount bracket with the supplied screws�
6� Adjust the angle of the wall mount bracket to aim at the shooting area�
1
2
5
4
3
6
5
4
6
IMPORTANT!
The supplied L-type hex key wrenches are exclusively
designed to match each screw� In case you will need to
adjust the lens later, do not discard the wrenches�