Filter
Top Products
Models
SPC-15R/15R SPC-30R/30R
Page -7-
MODELS
SPC-30R 30R
ASSEMBLY INSTRUCTIONS
Attach the electrode wires to the piezo Ignitor as
shown in Figures 6 & 7.
Figure 6
Figure 7
5.
OPERATING INSTRUCTIONS
MODELS SPC-15R/15R SPC-30R/30R
PREPARING FOR OPERATION
1.Check the heater for possible shipping damage. If any is
found, immediately notifiy the factory.
2.Follow all of the Safety and Operating Precautions.
3.Refer to the exploded view for general assembly layout.
4.Check the "O" ring on the POL before each use. Replace the
"O" ring if there is any sign of wear or damage.
5.Make sure heater regulator knob is on the "OFF" position.
6.(A) Attach the heater (30R only) to the guard on the propane
cylinder with the body of the stand on the inside of the guard
and the bolts through two holes in the guard (see Figure 1).
Tighten the latching plate into place using the wing nuts
provided (see Figure 2).
6.(B) Connect the POL fitting at regulator (15R/30R) to the
propane cylinder by rotating the POL nut counter-clockwise into
the propane cylinder's valve outlet and securely tighten with a
wrench. WARNING: Attach heater in upright position. Never
attach heater in a horizontal position. This could lead to
dangerous flare-ups or fire.
7.Securely tighen all gas connections.
8.Open the cylinder's gas valve and check all gas connections
with a soap and water solution. DO NOT USE A FLAME.
Figure 1
Figure 2