Filter
Top Products
Models
SPC-15R/15R SPC-30R/30R
Page -5-
MODELS
SPC-30R 30R
ASSEMBLY INSTRUCTIONS
1. Inspect the heater components for possible shipping damage. If any is found, immediately notify the dealer.
2. Follow the following instructions to assemble the SPC-30R /30R:
Check to make sure that all of the following packaged
components (see Figure 1) are incuded.
Burner Assembly w/ regulator 1
Burner Assembly w/o regulator 1
Heater Support 1
Tank Plate 1
Wing Nuts 2
Burner Clamp 2
Burner Mtg. Screw 2
Piezo Ignitor 1
Piezo Mtg. Nut 1
Figure 1
Insert the piezo ingitor into the bracket on the burner
support as shown in Figure 2. Then tighten the piezo-
mounting nut. Care should be taken not to over
tighten the nut.
Figure 2
1.
2.