Filter
Top Products
USSC 17
Your
Multi-Fuel
Heater comes to you with the glass door installed in place, ready for use. The glass is surrounded
on the edges with a gasket and seated in a glass channel. It is held in place with two (2) clips.
REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS
Open the door and then lift it off of the hinges. If the door is tight, tap gently on the bottom of the door with your hand
or rubber hammer. Lay door down on newspaper with glass clips facing you. Using a #2 Phillips screwdriver, loosen the
screws and take off the glass clips. Remove the broken glass carefully and discard.
Reverse the above procedure for replacing new glass with new gasket. Do not over tighten the screws. Over tighten-
ing can cause the glass to break.
WARNING
Do not operate unit with broken glass.
Do not substitute original factory glass.
You must use only factory authorized glass;
Do not slam door shut.
Do not strike glass.
Do not use abrasive cleaners.
CLEANING THE GLASS
When the re is rst started, it will produce some smoke. The soot might accumulate on the glass surface. Before the
glass surface gets hot, open the door and wipe the glass surface off with a rag. Do not touch the surface with your
hands. If after constant use, the glass is dirty, you must clean the glass so that it will not become etched with the y
ash. When the glass has cooled off, take a damp rag and clean with Hearth Glass Cleaner available from your dealer.
Do not use a rag that contains nylon because it will melt to the glass.
GLASS MAINTENANCE, REMOVAL AND REPLACEMENT
1
1
2
2
3
3
4
4
A A
B B
GLASS CLIPS
.
-