Filter
Top Products
FUEL DOOR
ILLUSTRATION
ASH DOOR
ILLUSTRATION
LOCK
WASHER
HEX
NUTS
ASSEMBLASSEMBL
ASSEMBLASSEMBL
ASSEMBL
Y INSTRY INSTR
Y INSTRY INSTR
Y INSTR
UCTIONSUCTIONS
UCTIONSUCTIONS
UCTIONS
COMBUSTION AIRCOMBUSTION AIR
COMBUSTION AIRCOMBUSTION AIR
COMBUSTION AIR
All fires need air (specifically oxygen) to burn. Furnaces, fire-
places, and wood-burning furnaces need enough oxygen for
complete combustion of their fuels. The incomplete combustion
that takes place when a furnace is "air starved" causes carbon
monoxide (CO) to be formed in quantities that can be dangerous
inside a well-sealed house. Having a source of combustion air
from outside prevents this "air starvation" of the furnace.
Drill one 7/8" hole as illustrated for placement of the Hotblast fan
limit control.
Your furnace is shipped from the factory in four (3) packages.
1) the furnace, 2) fan limit kit, 3) draft kit. Before assembling
the furnace, check to make sure there is no shipping damage,
and that all necessary parts are located in the firebox. See parts
list below.
If you find shipping damage or any of the parts missing, contact
the dealer immediately. He will take the necessary steps to
correct the problem.
Parts List Parts List
Parts List Parts List
Parts List
All models include the following:
Two Door Handles
FAN LIMIT KITFAN LIMIT KIT
FAN LIMIT KITFAN LIMIT KIT
FAN LIMIT KIT
One Fuel Door Latch Fan Limit Control
One Ash Door Latch Fan Center
One Shaker Grate Handle F.A.D. Box
Two 1/2" Washers 3-Speed Switch
Six 1/4" Hex Nuts Knob
Four Lock Washers
Spin Draft
Five 1/4" Lock Nuts
One Pivot Bracket
Four Brass Coil Knobs
One 1/4" x 1" Hex Bolt
Three 1/2"-13 Lock Nuts
One 1/2" x 2 1/2" Carriage Bolt
Six 1/4" x 3/4" Hex Bolts
Smoke Door
Two 1/4" x 1-1/4" Carriage Bolts
Two Smoke Door Clips
Rod Extension
DOOR HANDLE INSTALLATIONDOOR HANDLE INSTALLATION
DOOR HANDLE INSTALLATIONDOOR HANDLE INSTALLATION
DOOR HANDLE INSTALLATION
Insert door handle into door. From rear side of door place
1/2" washer over threaded part of door handle. Then attach
1/2" lock nut, being careful not to over tighten. Handle should
turn freely.
FUEL & ASH DOOR LATCH INSTALLATIONFUEL & ASH DOOR LATCH INSTALLATION
FUEL & ASH DOOR LATCH INSTALLATIONFUEL & ASH DOOR LATCH INSTALLATION
FUEL & ASH DOOR LATCH INSTALLATION
With two 1/4" x 3/4" hex bolts, attach the door latch to the
door latch mounting bracket on the left side of door frame as
illustrated. Adjust latch until door closes securely.
7
7/8" HOLE
6" (15.24cm)
3-1/2"
(8.9 cm)
SIDE OF HOTBLAST FURNACE
HOT AIR
PLENUM
FAN LIMIT
CONTROL ON
PLENUM