Filter
Top Products
7
Figure 2
Figure 3
Figure 4
Figure 5
Attaching The Handle
1. Remove the hairpin clips from the handle brackets and
remove the carriage screws and wing nuts from the
lower handle.
a. Place the bottom holes in lower handle over the
pins on the handle brackets and secure with
hairpin clips. See Figure 2.
b. Insert carriage screws through upper hole in lower
handle from the inside and secure with wing nuts.
See Figure 2.
2. a. Unfold the upper handle until it aligns with lower
handle. Make sure the rope guide is on the right
side of upper handle. See Figure 3.
IMPORTANT: Make sure the cables are routed outside
the lower handle. Also, do not crimp the cables while
lifting up the handles.
b. Secure the two handles by tightening the handle
knobs (carriage bolts must be seated properly into
the handle). See Figure 3.
3. Pull the two cable ties attached to the cables tight
approximately 8 inches from each cable end and place
the cables into the cable guide.
4. Loosen the wing nut that secures the rope guide to the
right side of upper handle.
a. Pull the starter rope out of the engine slowly. See
Figure 4.
b. Slip the starter rope into the rope guide. Tighten
the wing nut. See Figure 4.
Attaching The Hose Assembly
5. a. Slide hose adapter of hose assembly into the
base adapter located on the left front of the Yard
Vacuum. See Figure 5.
b. Pull spring loaded pin out on the base and align pin
with the first hole (closest to the end of the tube) in
the hose adapter.
c. Release the pin to lock the hose in place.
3
Setting Up
Your Yard
Vacuum
IMPORTANT
Make sure the cables
are routed outside the
lower handle. Also, do
not crimp the cables
while lifting up the
handles.