Filter
Top Products
8
Section III – Service and Maintenance
1. SERVICING AND MAINTENANCE
Beyond an occasional wipe down with a damp
cloth, the units need little in the way of
maintenance.
However, the units are designed to collect
airborne dirt and from time to time will require
routine servicing to remove the accumulation.
The service interval varies considerably between
applications, but typically will range from six
weeks in a busy bar up to several months in a
quiet office.
During normal operation, the unit will make an
occasional snapping noise. This is caused by
large pieces of dirt accumulating on the electronic
filter and is not dangerous. The Trion SE400E &
SE800E units have anti-arcing circuitry to
eliminate the nuisance of constant arcing. If,
however, the arcing occurs every minute or two, it
is an indication that the unit needs cleaning.
When a service is due proceed as follows:
a) Remove pre-filter and either vacuum clean it or
wash as described below.
b) To clean the electronic filter, soak it in a hot
(not boiling), a strong non-caustic detergent
solution cleaner.
Trion can supply an excellent detergent- TriDex-
obtainable through your Dealer. Alternatively, a
dishwasher detergent does an excellent job.
Soak the collector cell for several hours, then
rinse with clean water. Do not physically try to rub
the dirt off since this can cause damage to the
filter.
c) Allow the filter to dry thoroughly - preferably
overnight- and replace into the unit or alternatively
use force air dry setting on the unit.
Trion has a policy of continuous product
improvement, and reserves the right to make
changes in design and specification without
notice.